Pontiac Airbag Module Reset Service – Crash Data & Hard Code Removal

When your Pontiac’s airbag light stays illuminated after an accident, it is almost always caused by crash data stored inside the Supplemental Restraint System (SRS) control module. This internal crash record cannot be cleared with a standard OBD-II scan tool, dealership diagnostic equipment, or by disconnecting the battery. Modern Pontiac SRS units—whether built by Delphi, TRW, Bosch, or Autoliv—lock themselves after a deployment event to prevent tampering. Our professional reset service restores your original module to pre-accident condition by removing crash data at the EEPROM/MCU level, ensuring the module becomes fully functional again without any coding or reprogramming.

What Is the SRS Control Module?

The SRS or “Airbag Control Module” is the central processor for the airbag system. It receives input from crash sensors, seatbelt pretensioners, passenger occupancy sensors, and CAN bus signals. When deployment conditions are met, the module triggers airbags and pretensioners within milliseconds. After any deployment—sometimes even minor ones—the SRS module stores a non-erasable crash log inside its memory. Once stored, these records prevent the system from resetting, which keeps the airbag light illuminated until the memory is cleared professionally.

Common Pontiac SRS Codes That Our Reset Service Fixes

“Crash Event Storage Full”
“Deployment Command Recorded”
“Control Module Locked”
“Hardware Fault—Internal Error”
Seatbelt pretensioner deployment codes
Driver airbag deployment stored
Passenger airbag deployment stored
Non-clearable hard codes that return instantly after clearing

All of these are caused by locked crash memory, not live wiring faults. Resetting the module restores its ability to operate normally once reinstalled.

Pontiac Models We Support (1998–2010)

Our reset service covers nearly all Pontiac vehicles, including older models that use Motorola/Freescale processors and newer models using Renesas or Infineon architecture.

Pontiac G6
Pontiac Grand Prix
Pontiac Grand Am
Pontiac Bonneville
Pontiac Vibe
Pontiac Montana / SV6
Pontiac Sunfire
Pontiac Aztek
Pontiac G5 / Pursuit
Pontiac Torrent

If your Pontiac is not listed, it is almost certainly still supported.

Supported SRS Module Manufacturers

Delphi
Bosch
TRW
Autoliv
Siemens VDO

Common Pontiac SRS Module Part Numbers

These part numbers are extremely common in Pontiac vehicles and fully supported by our reset process:

10370169 / 10370170 / 10370171
09364488
15230038 / 15230039
19180979
25746225 / 25746226
22732115
GM 15279238
GM 15913309

If your part number varies slightly, it is almost always compatible. GM reused SRS architectures across many platforms, so different numbers often correspond to the same internal design.

What This Service Includes

We perform a full reset of the SRS module memory using professional bench equipment. Our process includes:

Reading the MCU or EEPROM memory (Motorola, Renesas, Infineon, NEC, etc.)
Identifying crash data structures and deployment logs
Removing stored crash events, lock flags, and freeze-frame data
Correcting checksums and data alignment tables
Performing post-reset integrity validation
Ensuring the module powers up without internal fault flags

Your Pontiac retains its original VIN, calibration, and coding. Nothing is altered except the crash data section, allowing your existing module to operate exactly as it did before the collision.

Why Reset Instead of Replacing?

Replacement modules often require dealer-only programming, immobilizer pairing, and compatibility checks. With a reset, your original module remains paired to the BCM, airbags, and occupant sensors. The reset procedure is also far more reliable than used modules, which often contain someone else’s crash data.

What This Service Does Not Fix

Water or corrosion damage to the circuit board
Bent, broken, or burnt components on the module
Open-circuit wiring issues in the vehicle
Faulty airbags, sensors, or seatbelt pretensioners

If your Pontiac still shows an airbag light after installing your reset module, there is a separate live issue in the vehicle that will need to be corrected.

After Reinstalling the Module

No additional programming or pairing is required. After installation, your Pontiac’s SRS system will perform a self-test. If all components are functioning and no live faults are present, the airbag light will turn off automatically.

Airbag Module Reset for Other Makes

We reset SRS airbag control modules and remove crash data for most major brands. Find your vehicle:

View all airbag module reset services →